Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateClopay Cable & Drum Replacement: The Mesquite Owner’s Guide
We replace Clopay-compatible cables and drums in Mesquite, and the installed price lands in our Cable Repair range of $130 – $250. Cable and drum failures are the kind of repair we can usually get to the same day, so if your door is stuck and your car is trapped behind it, call (844) 320-6569. This is high-tension work, but it is work we do constantly.

Most Mesquite owners don’t know the part exists until it tells them. You come home from the store, hit the button, and the door lurches up crooked on one side, or drops about six inches and stops dead. A neighbor walks by, looks at the slack cable coiled on the floor, and says, “That’s your drum.” That is when the phone calls start in Mesquite.
Which Clopay Models This Applies To
Cable and drum assemblies are everywhere in the Clopay line, but the parts are not universal. Standard residential sectional doors share a family of parts, including the Classic, Gallery, and Coachman lines, the Canyon Ridge composite series, and the Tuscany and Avante models when they use a torsion system. Doors with extension springs use a different setup entirely, so look up at the center of your door for the horizontal bar if you’re not sure what you have. You can find the exact model on the sticker inside a panel on the door’s face or on the jamb.
The catch: Clopay uses drums sized for the track radius (12, 15, or 20 inches) and for the door height. A replacement drum with the wrong radius will pull the wrong amount of cable per turn, and the door comes down crooked. Put a tape measure to your track curve before you buy anything.
As for OEM versus aftermarket, we install both. Original Clopay cast drums are heavy-duty and hold up especially well with a torsion cabled system, and aftermarket equivalents from a brand like Prime-Line are solid. What we look at is gauge (the thickness of the metal) and the finish, because a thinner cable in our sun and heat will fray faster. We want to be clear: we’re an independent shop and are not affiliated with Clopay. We source what fits your door. We don’t claim to stock Clopay parts or carry them on a truck. We get the right part, and we bring it with us before we touch your door. We service LiftMaster, Chamberlain, and Genie gear too, so if your opener is part of the call, we’re already there.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Signs Your Clopay Cable & Drum Replacement Is Failing
- The door hangs crooked or lops off to one side. One cable has stretched or broken, so that side pulls up while the other lags. This puts uneven pressure on both drums and the torsion springs.
- A visibly broken or snarled cable. You’ll see a loose, curled wire hanging near the drum or over the tracks. That’s the cable itself letting go, not the motor.
- A loud bang from the door or a slack spring. Usually a snapped cable has snapped the spring too. You’ll find the door too heavy to lift by hand, which is your warning to stop pulling.
- The drum slides or turns loosely on its shaft. A worn drum or a sheared set screw lets the drum drift, the cable winds wrong, and the whole door becomes a 200-pound problem.
- A scraping or popping when the door rolls. That’s a cable rubbing off its groove. Left alone, it wears through the drum.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For Mesquite, cable and drum replacement runs $130 – $250 installed, and that sits inside our general Garage Door Repair range of $150 – $600. Because we quote the job while you have us on the phone and hold that number in person, you’re paying the same price you were told, not one that grows at the door.
| Job | Typical installed price in Mesquite |
|---|---|
| Cable (one side) & drum | $130 – $250 |
| Both cables & both drums | $250 – $450 |
| Spring repair (if spring is also down) | $180 – $340 |
We replace both sides if both are worn, because they usually are and we’d rather not see you again in a month. Everything comes with our 90-Day Done Right Promise: if it isn’t done right, we make it right, and one call brings us back. Cables and drums, set correctly on a Clopay door, are a job you should be able to forget about.
DIY or Call Us?
Cables and drums under tension are dangerous. Straight up: this is not a part you should try to change yourself. A stretched torsion cable under 200 pounds of door weight will cut through a glove and keep going. We come across homeowners in Mesquite with a nasty gash and a half-installed drum on a weekly basis.
What you can safely do is look: check for a dangling cable, a crooked door, or a drum turning loose. What you shouldn’t do is loosen a set screw, cut a cable, or try to “relieve tension” with something in your toolbox. Take a photo of the door and the drum, then call. That’s all we need. Call (844) 320-6569, get an upfront price, and often when it’s a repair and not a replacement, we’re out the same day.
FAQs
How long do Clopay cables and drums last? The cables are the time limit, and in Mesquite’s sun and temperature swings we see the factory cables start to show wear around the ten to fifteen year mark. Our dry heat and grit slowly dry out and fray a cable that would last longer in a milder climate. That’s on top of drum set screws working loose from daily use.
Can the cable and drum be repaired instead of replaced? Usually not, and honestly a repair is rarely worth it. A snapped or twisted cable is a replacement. A loose drum set screw can sometimes be re-secured cheaply if we catch it early, but once the cable has frayed, the whole thing gets replaced. Call us and we’ll tell you which one you’re looking at.
How long does the swap take? A straight cable and drum swap on one Clopay door is usually a same-day visit that finishes within the hour, and we come with the right gauge and drum size for your door. If we have to find a part match for an older model, that could mean a return visit. Bring your model number to the call.
How do you source the right part? We measure your track radius, door height, and cable gauge (not just the brand sticker), and we pull from suppliers we trust, including original Clopay-style cast drums or dependable aftermarket equivalents. We won’t guess a size and force it onto a 200-pound door. If it doesn’t feel right in our hands, we don’t put it on your Clopay.
Call (844) 320-6569 for a free estimate, or to ask what’s involved with your Clopay door. We’re local, and we’ll see you on Saturday.
Written by the team at Otto’s Garage Door Mesquite.