Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateAmarr Cable & Drum Replacement: The Mesquite Owner’s Guide
We replace the lift cables and cable drums on Amarr garage doors in Mesquite for $130 – $250 installed, and most cable-job calls get handled the same day. That price assumes a standard cable-and-drum swap on a door still in good structural shape; a drum that cracked and chewed the cable can run toward the top of that range once both parts go on.

Owners usually find this the hard way. You back out of the driveway, hear a sound like a chain slipping off a sprocket, and the door stops halfway with one side hanging lower than the other. Or you pull up one morning and there’s a wire curled like a pig’s tail across the floor, the door half up and refusing to budge. That’s a cable that let go. In Mesquite’s heat, where summer highs sit over 105 and the inside of a garage gets hotter, we see the cables fail faster than folks expect. The drum is the round spool at the top corner that the cable winds onto. When the cable frays or the drum cracks, the whole door loses its balance.
Which Amarr Models This Applies To
This job covers essentially every Amarr sectional door we run into in Mesquite: the Stratford and Heritage lines on old homes, the Classica and Carriage Court on nicer properties, the Olympus and Olympia steel doors that are everywhere out here, and the commercial-grade Amarr 1000 and 2000 series. Cables and drums are matched to door weight and width, not to a trim package, so the model name matters less than the specs stamped on the door itself.
Here’s the compatibility gotcha that trips up online shoppers: Amarr uses different drum diameters for different door heights and weights, and a 12-inch-radius drum will not swap onto a door built for an 11-inch drum even though they look alike on a screen. The cable length and the drum radius have to match the door’s track radius and lift type (standard vs. high-lift). Wrong radius means the door hangs uneven or the cable winds off-center. That’s the reason we measure the door rather than guess from the model number alone.
On the OEM-vs-aftermarket question: Amarr’s factory drums are galvanized and sized to their spec, and a quality aftermarket drum of the same radius and cable-groove pattern works fine. What we don’t do is substitute a “universal” drum that’s close enough. We check the label inside the door frame and measure the drum, then match it. To identify your part yourself, look at the model label on the bottom panel or the sticker inside the jamb, note the door width and height, and measure the existing drum radius. Send us that and we’ll confirm the match before we come out.
We’re an independent shop, not affiliated with Amarr. We work on their doors the same as we do LiftMaster, Chamberlain, and Genie equipment – by the spec, not the logo.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Signs Your Amarr Cable & Drum Replacement Is Failing
- Door hangs crooked or binds partway up. One cable has stretched or slipped its drum, so the two sides lift at different rates. Left alone, the panel edges grind against the track.
- Frayed or kinked wire visible at the drum. The strands break one at a time from repeated winding under load, and a frayed cable is a cable that’s about to snap. This is the clearest warning you’ll get.
- A loud snap, then the door won’t open. The cable let go and the door is now dead weight on the springs. Don’t force it with the opener – that’s how panels bend.
- Cable off the drum and pooled at the bottom. Either the drum cracked or the cable jumped its groove. Riding off the spool usually means the drum’s worn and the groove is shot.
- Visible cracks or a wobble in the drum itself. A cracked drum will shear off under tension. On an Amarr door in Nevada heat, the galvanized drum and the cable both age faster than the door around them.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Cable and drum work in Mesquite runs $130 – $250 installed, and that’s the number we quote on the phone and hold when we get there. The range moves with a few things: whether it’s one cable or both, the drum radius and whether it’s a standard or high-lift setup, door weight, and whether the drum cracked and took the cable with it. We don’t add a trip charge inside the county, and we don’t revise a quote upward at the door.
What’s included is the matched cable and drum, the labor to wind and balance them, a full re-tension and door balance check, roller and track inspection so we catch whatever caused the failure, and a written 90-Day Done Right Promise on the work. If something’s off in those ninety days, one call brings us back.
| Service | Installed Price (Mesquite) |
|---|---|
| Cable repair / replacement | $130 – $250 |
| Drum replacement (with cable) | Included in cable range |
| Spring repair (often done together) | $180 – $340 |
| General door repair | $150 – $600 |
Any repair over $200 gets $40 off, and seniors and veterans get a standing 10% – always.
DIY or Call Us?
We’ll be straight with you: a garage door cable under tension is dangerous, and this is not a job to learn on. The lift cable on an Amarr door carries hundreds of pounds of spring tension, and the drum is what holds that tension in place. Cut the wrong strand, unspool a drum without backing off the springs first, and the cable can whip across the garage. People get hurt this way every year. A door is 200 pounds riding on two springs. Respect it.
What you can safely do is look, not touch. Check the door is closed and the opener is unplugged, eyeball the cables for fraying and the drums for cracks, and note whether the door hangs level. That’s diagnosis, and it’s plenty. Leave the winding and the drum swap to us. If it’s not done right, our 90-Day Done Right Promise covers the fix. Call (844) 320-6569 and we’ll quote it on the call and hold that number.
FAQs
Cables on an Amarr door here typically give you 7 to 12 years, and drums often a bit longer, but Mesquite’s heat shortens both – we see cables go sooner on south-facing garages that bake all afternoon. Rust, tight radius, and heavy use push it toward the short end. We’ll tell you what’s left on yours when we’re out.
Usually no. A frayed cable or a cracked drum is a replacement, not a repair – those are the parts doing the holding, and patching them is how doors fail again. Occasionally a cable that’s simply jumped its groove on a sound drum can be re-seated, and we’ll check that first. Call (844) 320-6569 and we’ll tell you straight which one you’re dealing with.
A standard cable-and-drum replacement on an Amarr door is about 1 to 2 hours, including re-tension and a balance check. A high-lift or heavier door runs a little longer. Most Mesquite cable jobs get done the same day.
We match the cable length and drum radius to your door’s label and measurements, then pull a quality drum and cable built to that spec – factory-equivalent, not a “close enough” universal. We confirm the match before the visit so the right part shows up the first time.
If your Amarr door is hanging crooked or you’ve got a cable on the floor, call (844) 320-6569 for a free estimate. A live person answers around the clock, we quote it on the call, and we hold that price at the door. For more on our work across the area, we’re glad to talk through what your door needs.
Written by the team at Otto’s Garage Door Mesquite, serving Mesquite and nearby areas.