Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateGenie Cable & Drum Replacement: The Mesquite Owner’s Guide
We replace the cables and drums on Genie garage doors, and in Mesquite that job typically runs $130 – $250 installed, usually the same day you call. A failed cable is a garage door that’s stuck, crooked, or sitting on the ground with one side hanging loose – and it’s not something to run to the hardware store for on a Saturday morning. The cable and drum are the parts that spool the door’s weight, and when a cable frays or a drum cracks, the door can drop without warning. We handle Genie systems across Mesquite because we’ve seen what a dry desert summer does to a cable that’s been sitting on a cracked drum for a couple of years.

You’ll usually find out the hard way. The door goes up crooked, one side lags, or you hear a loud snap and a bang from the garage. Sometimes you come home and the door is sitting at an angle with a cable coiled like a snake under it. Those are the calls we get most in Mesquite, and they’re all fixable when you catch them before the door comes down.
Which Genie Models This Applies To
Cable and drum setups vary by Genie model line, and the part that fits your door depends on the door itself – its weight, spring type, and how the cable routes to the drum. If you have a Genie screw-drive or chain-drive opener (the common residential lines here in Mesquite), the opener isn’t usually the thing that failed. The drum, cable, and torsion setup are separate hardware, and those are what we’re matching to the door. The cleanest way to identify the right part is by looking at the door, not the opener: the drum mounts to the torsion shaft at the top, and the cable runs from the drum down to the bottom bracket. Measure the drum and count the cable winding, check the spring setup, and that tells us what you’re working with.
OEM Genie parts fit cleanly, and quality aftermarket equivalents are a reasonable route when the OEM version is hard to source for an older model. We don’t claim Genie stock and don’t carry parts on a truck – we source the correct part for your door, and we’ll tell you honestly whether OEM or a good aftermarket match makes sense for your situation. We’re an independent garage door shop, not affiliated with Genie, so we work with the brand and its systems without being locked to one parts channel. We also service LiftMaster and Chamberlain systems, but for Genie cable and drum work, the matching is what matters.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Signs Your Genie Cable & Drum Replacement Is Failing
Here’s what we typically see, and what each one means. If any of these show up, stop running the door and call us.
- Frayed or kinked cable. The steel cable starts to fray near the drum or bottom bracket. That’s metal fatigue from years of winding and unwinding, and a frayed cable can snap without warning.
- Door goes up crooked. One side climbs faster than the other. That’s usually a cable that’s jumped the drum or a drum that’s cracked and not spooling evenly.
- Loud snap from the garage. You hear a bang and the door drops or sags. That’s a cable letting go under tension, and it’s the one that needs attention right away.
- Slack cable hanging. The cable is loose and coiled under the door. The drum or cable has failed, and the door is no longer supported on that side.
- Cracked or worn drum. The drum develops a crack or the winding groove wears smooth. That’s the part that guides the cable, and when it fails, the cable goes with it.
In Mesquite, the dry heat and the temperature swings between summer afternoons and cool nights work on these cables year after year. A cable that’s been on a cracked drum gets no warning before it fails.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
In Mesquite, Genie cable and drum replacement typically runs $130 – $250 installed, and that’s the whole job – the correct cables, the drums, the labor, and the safety check. The range moves with the door: heavier doors, longer cable runs, or a job that needs both drums and a spring check push toward the top. A single cable and drum swap lands toward the bottom. The price is quoted before we come out and doesn’t change between that call and your driveway.
Here’s what drives the range, roughly:

- Cable and drum replacement, standard door: $130 – $250
- If the spring needs attention too, spring repair runs $180 – $340
- Track or roller issues found during the safety check add their own line, quoted up front
Every job comes with our 90-Day Done Right Promise in writing. If something’s not right, one call brings us back. We also offer $40 off any repair over $200, a free second opinion on any written estimate, no trip charge inside our county, and a standing 10% discount for seniors and veterans.
DIY or Call Us?
You can safely look. Check the door from the ground: look for a frayed cable, a cracked drum, a door that’s off-level, or a cable hanging loose. What you should not do is put your hands into a high-tension cable and drum assembly. The drum holds a wound steel cable under load, and the door’s weight is riding on it. A cable can release with force that will break a bone or worse. We say this plainly: cable and drum work is not a homeowner repair, no matter what the video makes it look like.
If you see a frayed cable, a cracked drum, or a door sitting crooked, don’t run the opener hoping it’ll sort itself out. Call us at (844) 320-6569. A live person answers, we’ll quote the job on that call, and we’ll hold the number when we get there.
FAQs
Most cables and drums last years, not decades, and in Mesquite’s dry heat and big day-night temperature swings, the cable is the part that gives out first. A cable can look fine one month and fray the next. We’ll tell you what shape yours are in when we’re out.
No – a frayed cable or a cracked drum gets replaced, not patched. A cable is a single wound steel piece, and once it’s frayed or kinked, there’s nothing to repair that would make it safe again. The part is what it is.
The cable and drum swap itself is usually a couple of hours, and we’ll confirm the timing when we quote the job. We’ll also do a safety check on the springs, tracks, and rollers before we leave.
We match the part to your door and model – by measuring the drum and checking the cable and spring setup, not by guessing from a photo. We source the correct OEM or quality aftermarket part for your setup, and we’ll tell you which and why. We’re not affiliated with Genie, and we don’t claim to keep parts on a truck.
If your Genie door has a frayed cable, a cracked drum, or is sitting crooked in Mesquite, give us a call at (844) 320-6569 for a free estimate. We’ll quote it on the call, come out the same day when we can, and hold that price at your door. Genie cable and drum work is what we do, and we’re in this county to stay.
Written by the team at Otto’s Garage Door Mesquite, serving Mesquite and nearby areas.